02-03-2016 10:04 AM - edited 03-01-2019 12:34 PM
Hello,
Looking for a link to that shows how to add a member to a zone
Thanks in advance. All replies rated
02-03-2016 04:11 PM
Scott,
Can you clarify what device you're trying to add a member to a zone?
02-04-2016 07:13 AM
To add a member name to a Fibre Channel zone set zone member, use the member command in zone set zone configuration submode. To remove a member name from a zone set zones, use the no form of the command.
member { device-alias aliasname both initiator target [ lun lun-id ] | domain-id domain-id port-number port | fcalias alias-name [ lun lun-id ] | fcid fc-id [ lun lun-id ] | fwwn fwwn-id |
interface fc slot / port [ domain-id domain-id | swwn swwn-id ] | ip-address ipv4|ipv6 |
pwwn pwwn-id [ lun lun-id ] | symbolic-nodename nodename }
no member { device-alias aliasname both initiator target [ lun lun-id ] | domain-id domain-id port-number port | fcid fc-id [ lun lun-id ] | fwwn fwwn-id | interface fc slot / port [ domain-id domain-id | swwn swwn-id ] | ip-address ipv4|ipv6 | pwwn pwwn-id [ lun lun-id ] |
symbolic-nodename nodename }
02-05-2016 01:08 AM
02-05-2016 07:16 AM
for reasons I don't understand, I never get to slide 36. I have everything else configured as shown (except I have an IBM V7K), was able to see and install to the LUN when I booted the VMWare install disk from kvm.
I have a TAC open.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide