Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
- devices: C9500 (stackwise) and C4500 (VSS) - trying to build port-channel but getting the following errors: *Nov 9 15:40:04.795: %PM-4-ERR_DISABLE: channel-misconfig error detected on Te1/1/7, putting Te1/1/7 in err-disable state *Nov 9 15:40:06.19...
Hello, I've recently migrated 1 building worth of access points to the new 9800WLC. Everything is working swimmingly, except Vocera Broadcasts, which use multicast. I have this working fine on my old 5508s. I've tried enabling global multicast under ...
I currently have my UCS environment setup with a single FC connection from 6248 to Nexus5548UP UCS-A ------> 5548-1 (VSAN700)USC-B ------> 5548-2 (VSAN701) UCS side looks like this: Nexus 5548 port looks like this:interface fc2/7switchport descriptio...
Sooooooo, I believe I am at least part-way to having this configured properly. I've zoned, assigned storage, configured boot from san on the UCS.
I installed vmware by mounting the CD image, booting from that, installing from my SAN LUN. Did a touch...
I've just installed 19 new 2702 APs, and for reasons I can't figure out, my core switch can't settle on an ARP entry for any of them. My core switch is also the DHCP network for this vlan (253). For example one APs ARP entries look like this: Interne...
I know I am kind of bringing this thread back from the dead and all
"What had occurred with the system recently? Reboot for any reason? Either upgrade, or maintenance... power fault/hard reboot, etc.?"
So this thing will rebuild the RAID if it re...
for reasons I don't understand, I never get to slide 36. I have everything else configured as shown (except I have an IBM V7K), was able to see and install to the LUN when I booted the VMWare install disk from kvm.
I have a TAC open.
I don't *think* it's the 5508 replying to the arp requests. It could be something else, though. I may need to get on the console of one of the misbehaving APs and see if I can pick anything up from there.
