Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently using an ASR-1001X with two 10G interfaces – one out to our WAN and the other going back to our core. Both of these links are capable of 10G.Current license configuration: two 10G Interface Licenses, and one 10G Throughput License.But, as ...
I've tried different channels and different channel widths.I've looked at radar event counters, but they're not incrementing.I've run my config through the wireless config checker.Interference and noise aren't terrible and I have a terrific SNR.Yet t...
Have a setup with a 9800-L and two 1572 mesh APs. One AP is root (parent), the other is mesh (child). The parent root AP is wired to the main LAN where the 9800 sits. The child mesh AP has a switch trunked to its ethernet port. The switch traffic...
Howdy, Does anyone know a way to download/export the configurations I've performed on CUCM in Sandbox so that I can quickly get up and running the next time I start a session?
So, I did a few dumb things. First: I shutdown the management port.Second: I entered a 'no exec' command under line con 0Third: I did a 'copy run start' and then reloaded the machine. Now I cannot get into the switch except via breaking into ROMMON ....
Thanks for the replies, all, esp @Haydn Andrews and @Arshad Safrulla Recently upgraded to 17.3.6, and this resolved the issue. Software bug ... assumed I had configured something incorrectly. Drove me nuts.
Ammahend, thanks for the reply. Still curious about what's different about the security of traffic flows when comparing bridged ethernet and WiFi traffic. WiFi traffic in the mesh network is secured by a CAPWAP tunnel that's setup as you mentioned a...
