Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a /29 range from my ISP. One address in the range is assigned to the outside interface. I would like to use the remainder of the range for mappings to my DMZ servers. I ASDM, I created the access and NAT rules but I must be missing some...
Hi All,Trying to understand why this is happening and where to fix it. Example: An external caller calls my desk, its forwarded to my cell phone and the caller ID shows the callers number with an 8 in front of it. This is the number to make an extern...
Hi All,I am looking at the Port-Channel configurations between these two devices and noticed that on one side it seems Native VLAN tagging is disabled and on the other side it appears to be enabled. Does anyone see an issue with these interface setti...
Hi,Here is some of the config from the VG. Does this show where are we adding the (8) to calls sent to the phones and is there a rule I can add to strip the (8) on calls being forwarded to their external phones? Do you need more of the config? Thanks...
Thanks for the assistance. I looks like I am too much of a beginner to find this on the gateway. I see on the route pattern configuration under Called Party Transformations that discard digits is set to PreDot. I assumed this would accomplish removin...