Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We use 0 dial out and ever since we have migrated to sip trunk we get full e.164 DID on all inbound calls. Which means we receive +1<10 digits>
Problem we are having is on call back so if we have a missed call, we need to do edit dial and get rid of ...
Hello Experts,I have a question about Cisco Aironet 1310 AP, the problem I am getting is that I am unable to enter the conf t mode to configure the AP. I am not sure what could be the problem. I have IOS 12.3 running on it.Please help
Hello Everyone,We have a Cisco slm248gt-na smart switch in our office that I am trying to configure to support and optimize for VoIP. We have desktops hooked up off the phones in most cases. Are there any config guidelines to optimize the switch so i...
Hello,We have CUCM 8.5 deployed and working in our environment. We also have Cisco 7925G Wireless Phones that we want to deploy and configure for the environment. We have Cisco APs in our environment. Any direction on this regard will be highly appre...
Hello,I just downloaded and installed the CISCO IP Communicator, added it to the CUCM 7.1.5 phones list and when I am trying to configure it on my laptop, the network .... preferences tab is greyed out so thats why I am unable to input the IP address...
Hey Steve,Its k9w8, this is what I see on sh verCopyright (c) 1986-2006 by Cisco Systems, Inc.Compiled Mon 17-Jul-06 11:45 by alnguyenROM: Bootstrap program is C1310 boot loaderBOOTLDR: C1310 Boot Loader (C1310-BOOT-M) Version 12.3(2)JA4, RELEASE SOF...
