When I use my mobile phone to dial the switchboard, then transfer to the extension. If no one answers, it will ring for about 60 seconds. Where can I change this time?Voice gateway: ISR4331, H323 gatewayCUCM version: 12.5
We have two SSIDs. One of them is connected normally. Another guest SSID cannot connect. Prompt that this network cannot be connected.The following is the log of debug with a clientWLC:3504 version:8.5.140AP:2802i
We purchased four 2802i aps. Since the maximum supported power of the switch is only 15.4w, we bought 4 poe injectors (AIR-PWRINJ6).The strange thing is that when I look at the controller, the ap status is still medium power (15.4w). And the radio ca...
We have 37 APs. AP models are all 3802. Only 23 devices can be seen under 802.11b/g/n, as shown in the figure below. You can see 51 devices under 802.11a/n/ac. Some customers told us that their devices that can only use 2.4Ghz cannot connect to wifi....
I tested it and there seems to be a problem. Because we call the AA script on the voice gateway. For example, if there is no answer from an outside line to an inside line, the voice file of the service AA script will be run "The call you dialed is te...
