Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to comprehend the following output of the show queueing interface command. It seems to be indicating matches on the high queue even though the high queue is not configured. Also, there are no matches indicated on the medium queue but matc...
I am troubleshooting an issue on a T1 where data latency spikes, but total bandwidth does not. I am interested in learning how proportional bandwidth sharing applies to the default class. The below document states, "If not all of the bandwidth is all...
In the course of troubleshooting some transmit discards I noticed something peculiar. The output queue length on the discarding interfaces is 0. Shouldn't this be the default length of 40?GigabitEthernet0/18 is up, line protocol is up (connected) in...
I am looking at possible solutions to provide inter-vrf routing on a 6500. Does the following look workable?int vlan1ip vrf forwarding redip address 2.3.4.0 255.255.255.0int lo0ip vrf forwarding redip policy route-map redroute-map red permit 100set v...
Why does Cisco not offer round-robin load balancing for etherchannel?I understand that round-robin can result in out-of-order packet delivery, but tcp is well equipped to deal with this issue. Per-packet load balancing is achievable at layer 3, so wh...
If it is a dynamic route to the destination on the default gateway and that route goes away, then the default gateway may send icmp redirects for whatever route now matches the destination. Some switches fail to properly timeout redirects.
I have recently done some analysis of dscp values coming in from the internet. Some internet traffic is tagged such that it is utilizes queues on the private wan reserved for voice and video. It is apparent that a trust boundary must be established. ...
