Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello i hane new journey with cisco DNA catalyst , i tried to new installation for my dna server in maglev configuration wizard 1.1.0 , and stopped here in picture the server still install and try in day0_default then stopped with new graph below i...
we connect the uplink for standby WLC (CW9800M) with core switch and port down but i receive RX power for this portif the port will be up after switchover ?can you help me ?
Hello dearI need your support to know if i can to bridge L2 VLAN with L2 Sub-interface in the same device C9500-48Y4Cto pass the service through this VLANRegards
hello dear i know this menu , but after i completed the initial configuration as IP and gateway and select the default install after some minute return to this menu as picture attached
it is already connected and there is no issue when check the active and standby device but when we connect the uplink port for standby WLC the port is down but i receive the RX power is that port will be enable after the switchover ?
we connect the uplink for standby WLC (CW9800M) with core switch and port down but i receive RX power for this portif the port will be up after switchover ? can you help me ?
