Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
We have a 3850 chassis which show the below error message in the log.
Unfortunately i can't find any informations related to that error code neighter on cisco.com nor on google.
3850_SW#sh ver
Cisco IOS Software, IOS-XE Software, Catalyst L3...
Recently there was a failure to ACE10 hang occurs.Service recovery is solved by the ACE module "hw-module reset".I'll use the EEM and "ip sla" for the auto recovery..However, often occurs due to a "parity error" in the reload ACE10. I want to be....I...
Hi all.We prepare to upgrade and review from ACE10 A2(1.4a) to A2(3.6a) version.Looking for reference sites using a version A2 (3.6a)Please tell us reference sites. Thank you.
Hi allIn the following stepStep 2 working at service downtime occur?To upgrade the ROMMON version on your CEF720 module, perform these stepsStep 1 Check the active ROMMON information:Router# show rom-monitor slot 4Region F1:APPROVED, preferredRegion ...
Hi all.We prepare to upgrade the IOS and reviewing the 12.2(33)SXJ5 version.IOS 12.2(33)SXJ5 version of the reference site inquiry.Please help me.Thank you
In the context of Cisco Embedded Wireless Controller (EWC), AP clear mode typically refers to a process or command used to reset or clear the configuration and data on an Access Point (AP). This is often associated with the clear ap config command, w...
We perform the upgrade had no problems.
This error cause any problems can be?
3850_SW#$3k_caa-universalk9.SPA.03.07.03.E.152-3.E3.bin switch 1-2 Preparing install operation ...[1]: Copying software from active switch 1 to switch 2[1]: Finished copyi...
