Does anyone know how to configure a meet-me conference on a UC500 via the CLI? The configuration notes for CME 4.2 don't seem to apply, since the UC500 does not have the required dspfarm pool. I would appreciate any help! Thanks, Dennis.
Does anyone know what this means?Here's the complete log (the err-disable and then re-enabling of the port):001798: Aug 31 17:49:19.809: %ETHCNTR-3-LOOP_BACK_DETECTED: Keepalive packet loop-back detected on FastEthernet0/14.001799: Aug 31 17:49:19.80...
I'm having a problem with port-channels failing between two 6513 chassis with sup 720s and the 6724-SFP line cards in high throughput situations. The IOS is 12.2(18)SFX5. Has anyone else ever encountered such issues? If so, what was the resoution. Th...
I'm having troubles following this logic; what does this ip nat and route-map combo actually do?ip nat inside source route-map nonat interface Vlan20 overload!access-list 140 deny ip any any!!!route-map nonat permit 10 match ip address 140Thanks fo...
Thank you for your reply.I'm new to the UC500 and CME platform in a lot of ways (coming from full server-based CallManager), so I might be missing something here. This is what I see from the command line:Before Config:#sh dspDSPFARM Configuration Inf...
Thanks for your help. Not sure if a headset is attached, but I'll check. As for the other questions, here you go:3550-02-pwr#sh verCisco Internetwork Operating System SoftwareIOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(19)EA1a, RELEASE SOF...
To further this... do you know what the oversubscription is for the WS-X6748-GE-TX and WS-X6724-SFP modules? If you were to build an etherchannel group, would you go across a card utilizing seperate ASICs, or across slots to utilize the bandwidth of ...