Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We installed 5 each 3750 switches using Stackwise and tested the auto upgrade feature. We were unsuccessful using this feature. Our Image file is a .bin file which our SE believes can be used to auto upgrade. The show boot command shows the master ha...
I constantly receive trap information on 3750 switch for interface up/down and would like to disable this notification. Is there some way to disable the notifications for workstation interfaces and keep trunk interfaces active? Thank you for any assi...
Requesting assistance from Unity VM experts on this issue. We have Unity4.2(1) VM only using TSP 8.1.2.DC with Exchange2000 backend servers. Using CM 4.1(3)SR4D.We have two instances where users are unabl e to access VM although MWI is on. We have va...
Using CM4.1.3 SR4D, I recieve device trnasient connection errors on various ATA devices from the subscriber. The CM Web admin shows devices are registered with subscriber. I have reset devices and viewed in subscriber event app log and still see the ...
Our Unity primary environment using 4.2(1), we are unable to create subscribers in SA Web. The radio button is grayed out. I have logged into the server as administrator and rerun Cisco Unity Message Store Config Wizard and ensured we selected add ne...
DritanDid you receive an answer to this? I have the same issue but believe the Sup1a does not recognize the disk0: and must use slot0:. I just wanted to confirm.
Using another crypto IOS version which was clearly lower than the IOS on the master we finally obtained version mismatch. It was my understanding that the auto upgrade would occur but it did not. In the log we received the following:Systems with inco...
We downloaded a .tar file on master and extracted to all members of the stack. We then introduced another switch using an image consistent with the master but with a lower revision number. We cabled up the 5th switch and powered up waiting for auto u...
Thank you so much for the info. I was very helpful and appreciate your expertise. I will test this out in the lab and determine whether or not to enable auto update or manually have control of IOS Upgrading.
Thank you for your information...Based on documentation the .tar file was necessary for auto upgrade. The confusing part is once the .tar file is extracted, it creates the structure with config.text,vlan.dat,private-config.text and image directory. W...
