Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Community,Hope everyone is well.Recently i am facing difficulty with implementing my wireless network.i have installed wireless access point and all of them successfully appearing in my wireless controller dashboard, WLAN created for the...
Dear Cisco Community.Hope everyone is well.anyone created cisco smart account recently?!i need some help with that,i already opened case with cisco but just wanted to see if anyone experienced that before jump onto meeting with cisco!?It keeps asking...
Hello Cisco community,I am planning to deploy Wireless LAN controller C9800-L-C-K9 to manage my access points.I have 75 access point i want to deploy them, my access point models are 9120AXI-E.My question is do i need any license for activate them i ...
Hello Folks,I am labbing SD-WAN on eve-ng.I am using 3 cEdges, all onboarded into vManage but all of them showed unreachable.their system ip is not reachable on vManage.on vSmart when i run show omp peers or routes i cannot see anything but in vBond,...
Hello Folks,My Router CPU is getting to 99%.MY LDP destroyed many times because of that as i searched through community they suggested to factory reset smart license then reload the router.my question here is this:Does factory resetting smart licens...
You dont have to create any more VLAN just try to separate client traffic with Access points management VLAN.For example make VLAN 50 just for client traffic and attached to WLANand VLAN 10 for Access points management VLAN.
Thanks Flavio,This solved my issue:I had two VLAN 10, 50 On controller: - I created SVI 10 for Management purpose. (removed IP helper address under this interface)- Created L2 VLAN 50 for Wireless users attached to WLAN.- Disabled DHCP Server- Disabl...
