Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 20 VRFs to be precise in our infra and we need to create L3-out for external connectivity .
Is it possible to create single L3-out with 20 VRFs? or is there any concept such as per VRF L3-out?
If not then can we cut down the 20 VRFs to single...
Failed to initiate backup. Server [CUCM-PUB], component [CLM] requires component [PLATFORM] to be registered.
Did the following troubleshoot as shown below
utils service restart Cisco DRF Local
utils service restart Cisco DRF Master
Post which ran t...
Hi, There are two Vlans in a port Voice and data, users are using only one cable to connect to both the services.Cable coming from switch port is directly connected to IP phone.then another cable from IP phone is connected to end user system.IP phon...
I have deployed a new CUCM 12.5 cluster and I want to migrate all phones from old cucm 11.5 to new cucm 12.5 ...and I need to delete the ITL file of the phone because without that phones are not getting resisted to new cucm ...but the challenge is w...
Can it be possible to form a etherchannel connectivity between to stacks i.e (between 3850 stack and 3560 horizontal stack) ?Is there a compatibility between 3850 and 3560 switches ?
Failed to initiate backup. Server [CUCM-PUB], component [CLM] requires component [PLATFORM] to be registered.
Did the following troubleshoot as shown below
utils service restart Cisco DRF Local
utils service restart Cisco DRF Master
Post which ran...
Hi sir, As per cisco document one method to migrate phones in between non secure clusters is to set “Prepare Cluster for Rollback to Pre-8.0" to true on source cluster and RESTART THE PHONES which will only blank out the ITL file.My only question is...
