Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After initializing the ASA settings, an error was output when the following settings were submitted. Could you please tell us the cause and how to configure it?
(config)# crypto ikev2 remote-access trustpoint XXXXXERROR: Trustpoint not enrolled. Pl...
We have a multi-chassis LAG with ASR9000 routers, and we are aware that if the uplink on the Active side of the ASR9000 router goes down, the bundled Ethernet on the downlink side will not switch over.
In this case, I am aware that a bypass route ...
I configured an IP address on the bundle sub-interface of the ASR9000 and pinged the IP address, but got no response. I would like to know the cause.
interface Bundle-Ether2000.5vrf TESTipv4 address 1.1.1.1 255.255.255.0load-interval 30encapsulatio...
For the output results of the following commandsCould you please tell me what it indicates?Also, I have port channels in a stacked configuration, and the Group Mask values for active and standby are different, can you tell me the possible cause?
show...
@balaji.bandi
I can't post the output of the command, but I did check it and found the following
#show crypto ca certificate
<No applicable trust points>
#show crypto ca trustpoints
Trustpoint XXXXX:Not authenticated.
Hello M02@rt37
The target sub-interface is up/up.Loopback address and mgmt address had no ping errors.
Interface IP-Address Status Protocol Vrf-NameBundle-Ether2000 unassigned Up Up defaultBundle-Ether2000.5 1.1.1.1 Up ...
