Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to configure a HWIC-16A as a terminal server without success. I can get a telnet session to connect, but I simply get a blank screen, no data appears to be sent or received over the serial line.The only similar post I could find was https:...
I've got a strange issue where an IKEv2 VPN terminated on an IOS G2 router is not setting the DNS suffix (DHCP option 15). This can be observed on both Windows (built-in VPN client) and Android (also built-in VPN client).The same router also has L2TP...
Are there any known interoperability issues or more-specific causes of very high Jitter numbers in the call stats, such as the attached? Should the attached example be just considered invalid, or indicative of severe network issues?In this particular...
Am I missing something, or is there a bug (IOS 15.7(3)M8) which would seem to make the following combination of commands totally incompatible?I have tried with separate inbound/outbound dial peers, and even wiping the whole config down to a single di...
On an ISR G2 running CME, when "debug voice application error" is enabled, the logs are continually flooded with the error://-1//TCLM:/tcl_hunt_group_num_calls_in_callq: B-ACD-SERVICE Tcl service not availableI have tried installing the b-acd scripts...
Thanks, really appreciate the suggestions.This is on a 2900/3900 platform which don't seem to have the hw-module subslot command unfortunately (only for sm and PVDM modules). I did try anyway in case it's a hidden command, it appears to be IOS XE onl...
It would probably be easier for me to move the module into a spare 2901 I have sitting around, as the device it is currently installed in has a fairly complex voice config over 2000 lines. Is there anything specific I can confirm before doing that?I'...
Sadly I can report that the speed, flowcontrol and async mode commands suggested by @paul driver didn't work, and neither did a reload, but thanks for the suggestions. The speed 9600 command appears to be the default as it didn't save in the config. ...
Hi,Thanks again for the suggestions, in relation to "access-class TERMSERV in vrf-also", it has been tested without that command and unfortunately it didn't work. This command was added to disable pre-login authentication for testing, as per the earl...
Hi Pieter,Thanks for your suggestions.> 1) it would be nice if you received (and kept) some of the RJ45 to DB9 or DB25 connectors packed with some Cisco devices.Yes. I have plenty of the DB9 rollover cables which came with various routers and switche...
