Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I'm asking about the End-Of-Support date of the ASR9K boxes, I've found some documents about IOS XR not about the hardware itself.Actually we are going to consider bunch of these boxes in the core network, so I wanna know how many years appr...
Hello All,I have couple of Nodes with the same IP addresses , unfortunatley they're fixed and can't be changed at all !!, I'm gonna connect them via my Network to be accessed remotly, how can I make it ?kindly refer to the below diagram: Thank you al...
Hello All ,I have Cisco 1841 router that has two add-ons cards which are ADSL WIC card besides 3G one , I used Password recovery procedure to access it using the console cable , I surprised that I don't have "Cellular" and "Dialer" interfaces when us...
Hi All ,I have the following scenario :I'm going to make two connections between the HQ office and site1 using GRE over IPsec with OSPF routing,at each site I'm using ADSL line besides 3G (as backup), and the target is to use Loopbacks as source and ...
mmm, then I think my turnaround solution is gonna work in this case; Actually I have Console Server connects Serial ports and gives each one of them Virtual IP, I can use Ethernet to Serial converter for these hosts, then to connect them to my Consol...
Thanks for your response , what do you think about Sub-interfaces at the Router and VLANS at the switch to seperate these hosts ? & then to make NATing some how.
