Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , i have primary FMC1 working fine with 3 ftd registered to it. i have setup secondary FMC and joined fmc 2 to fmc 1 . it seems that fmc are connected and getting synced but no ftd get registered on FMC-2 so FMC2 shows degraded status because fmc ...
Hi, i have a strange problem in my campus network.im trying to run port security on my access switches which they are 3550 with ios c3550-ipservicesk9-mz.122-52.SE when i run the port security with Sticky option, even i put 1000 mac address for just ...
Hi every one, i need to know that is there any way to push down a contact list to cisco ip phones via call manager or something else so users dont need to create contact list on their phone manually and alos is there a feature like auto entering so...
Hi every one,we have 7606 router without any ipsec module on it,so i check the ios and it has all commands in interface tunnel for configuring the dmvpn multipoint tunnel and also protection profile for ipsec! so i have this question: do we can run ...
Hi every one.we have a 878 router and we want to mark traffics when entering on its lan interface.its lan interface is a layer 2 interface and we have created vlan interface and assosiated lan interface to that vlan.on vlan interface itself there is ...
hi Marvine, thanks for reply, in this moment with only one active fmc im not sure i can risk to go through upgrade process. i should also add some info that, before this happened, i had a fmc2 that was working ok and with ftds registered to it, but i...
HiFMC= 7.3.1FTD= 7.2.5.1there is no error except in FMC high availability screen it show my all FTDs in pending state to register on FMC-2. and in ftd only shows fmc 1 as manager there is nothing about fmc 2
Hi, thank you guys for your reply's, i have to mention that fast 0/24 connects to 20 to 30 pc and i just put 1000 mac address in the configuration just for testing even i know there is not that much users on that port. about show port-security output...
thanks for reply. actually i dont wnat to use CoS bit marking,i want to use dscp marking but my problem is that this version of ios doesnt support service-policy on vlan interface,actually in 6500 switches we can use service-policy on vlan interfaces...
