Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI,
Any one can assist me, i noticed some of the segment OSPF neighboard became INIT, We have 2 CS which run on HSRP.
MKLDC-10-6509-1#show standby briefP indicates configured to preempt.|Interface Grp Prio P State Active addr Standby addr Group add...
My router not getting IP Address after reload.
Interface IP-Address OK? Method Status ProtocolGigabitEthernet0/0/0 192.168.231.9 YES NVRAM up up---GigabitEthernet0/0/1 unassigned YES DHCP up up---
Gig 0/0/1 Connected to ISP Router, since we not gett...
Hi,
I believe the Cisco 9148S already EOL. Anyone know where I can find second hand / refurbish unit for this model. Also there is any license required ?
What is the suitable replacement for Cisco 9148S.
Thank You.
Hi.
I have CUCM 12.5 and configured DND for certain phone number.
After applying & save the configuration setting. Within few minutes the configuration rollback to the previous setting.
Any one has encountered this kind of problem before.
TQ
Hi.
Is that possible to connect multiple storages in 2 MDS Switch? Cause i already perform the setup but not sure if it correct or not.
Details config and setup as per attached.
Appreciated any assistance & help regarding this matter.
TQ
Hi MHM,
Thank you for you suggestion and respond, will disucss this with team since shut the Po will have impact to our current production traffic, but i now sure if shut the specific port. Previously we already remove the Qos but nothing happen and ...
Haha, because no command for show port-channel,
------------------------------------------------------------------------------------
MKLDC-10-6509-1#show etherchannel summaryFlags: D - down P - bundled in port-channelI - stand-alone s - suspendedH - ...
I run again now (afterb 11m), interface 4/1 got increament by 1. interface 4/2 remain same.
----show port channel summary----
MKLDC-10-6509-1#show interfaces port-channel 1 summary
*: interface is upIHQ: pkts in input hold queue IQD: pkts dropped fro...
