Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
are there any plans to support the Nexus 5648Q in Cisco Prime Infrastructure? This model is not really new, but also with recently released device pack 3.1.3 it isn't supported in PI.
I'm asking for a customer which is currently using >15 of...
Hi Community,I need to decode a "show stacks " output. While doing some research and reading AFROJ AHMAD statement in post (Getting High CPU S720 due SNMP Prime) i figured out that i need to find some "symbols.gz" files for the corresponding IOS ver...
Hi,I have here two Nexus7k chassis and I want to make use of the CFS feature. As far as I understood, it is using multicast for synchronising the configuration on both chassis. Both SUP management interfaces are connected to an old 3550 rackswitch an...
Hi,i would like to know if the ASA is still handling ipv6 in software (like the FWSM for example), or is it using its powerful hardware to handle the ipv6 traffic?Best regardsPhilipp
Gents,we were unable to save the running-configuration of our Nexus7000 due to the error:"Configuration update aborted: another request for config change is already in progress"I was assuming that we were hitting a known bug with the NXOS 5.1.1(a) (C...
hi Ronald, be also aware to allow protocol 41 when you bind access list to the interface you are using for the tunnel. happened to me lately cheers philSent from Cisco Technical Support iPad App
You are right. Rebooting the whole chassis is something i wanted to avoid. In addition this was a bug in the software revision i used. This shouldn't happen again, once you upgraded to > 8.1.3.Phil