Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I do have a Cisco Room Kit registered on my CUCM and I would like to invite/add more than one device during the call.
This action can be done over activating the multisite option or there is other prequisites needed ?
Hi team,
I have two users owning 2 Cisco IP Phone the audio call pass correctly between them but the video call don't pass, I think that the problem is related to the Codec ?
Please note thet one user is connected to the network via a VPN IPsec tunne...
Hi community,
I have a problem in my CUCM it sounds like it might have lost the sync.because the licenses where forwarded to the customer's smart account.
Should I deregister and reregister the SSM in CUCM License Management ? and how this action ca...
Hi team,
I'm deploying CMS version 2.9.1 and I have some questions/problems :
1/ After creating a space . but when trying to join meeting with (id/passcode), "Could not find meeting" error message appears ? Anyone knows how to solve this please ?
2/...
Hi @Wayne DeNardi @gbeelitz2010 ,
I have a Room kit device registered in my CUCM and I want to activate the multiste option (Joining more than one usere in the same call) and I do have already purchased the license, so I have some questions :
1) Is t...
OK just I thought that there's another tool to collect logs directly for the phones.
I'll share with you the logs.
Meanwhile you can find attached the sip trunk profile configuration
How can I check if the port ranges configured for Audio and Video in CUCM (in the sip-profile used on the phones).
How can I collect the logs of the call?
Hi @b.winter ,
I have checked the region and the location settings , also the video capabilities are well enabled.
During the video call i have noticed that only the sender packets are generated but the received are always 0.
It can't be a protocol w...
Hi @Nithin Eluvathingal ,
Licenses are already on our Cisco Smart account.Just we need to activate them on the CUCM.
else, how can we renew authorization ?
