Hi, guys This is my physical network design i did it like this I dont know its a right way or not I used Three tier architecture.So how to convert this physical into logical network design Kind Regards
Hi I am doing GLBP for ipv6 but during configuration i am unable to see this option # glbp 1 Ipv6 2001:db8:A:10::1/64 instead of this i am only able to see # glbp 1 ip "ipv4 address" i am unable to enter ipv6 address
Hi, I am doing OSPFv3 in IPv4 Network, for my topology i have area 3 connected with area 2, i want to run virtual link between area3to area 0, pls help me how can i do that
Hi, Here DMVPN is working fine i can ping from hub to spokeBut from Hub to Vios I am running ospf 1 this is the config Viosint gig 0/0ip add 10.11.3.1no ship ospf 1 area 0 On hub router int gig 0/1ip add 10.11.3.1no ship ospf 1 area 0 So i can't pin...
Hi,I am doing dmvpn I am unable to ping 10.1.1.2 which is spoke from hub and i cant't see any route in hub routing table on tunnel interface and i am doing eigrp on overlay but i am unable to create eigrp adjacency between hub and spokethis is my co...
Okay I got that part and how can i give the logical design and ip addressing scheme like supoose i have 8 vlan and 4 vlan has 2000 users and 4 vlan has 1000 users
So as for my physical design this one is okay i need to do logical I am using cisco 9500 switch at the core layers so i will give the ip on the same design and how can i give the ip address scheme