Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Sir,I have voice Bandwidth on Cisco Router 7200 and catalyst 3750.Now i want to sell some BW ( 15MB ) to any cleint. Can you please explain how to do that .We have ethernet connectvity with my cleint.How i restrict client to 15MB. Will i have ...
Dear Sir,I have one more scenario problem if you please guide :The scenario is i am reciving the call from PSTN on cisco gateway 5400 and which forwards the call to softswitch. Now i am using two stage dialing for this scenario. The customer called 1...
Dear Sir,i want to throw calls from specific ANI to session target B. and for that I have implemented following dial-peers in which command answer address is used in second dial-peer but its not working.dial-peer voice 1001 voip description Towards ...
Dear Sir,I have DVD of Cisco CCM6.0.1.iso, one configured voice gateway AS5400 with TDM E1s, and one blank server with good specs.Can you please guide how to setup voice network with CCM?Previously we are using voice network using AS5400, Nextone(sof...
and also :LHR-3750(config-if)#service-policy in CLIENT-INLHR-3750(config-if)#service-policy out CLIENT-OUTpolice command is not supported for this interfaceConfiguration failed!Warning: Assigning a policy map to the output side of an interface not su...
Dear Dan,When i created a policy then what to give normal burst bytes and maximum burst bytesis this Ok police 15000000 1875000 exceed-action drop*15000000 / 8 = 1875000 Please guide.Regards,Bilal
Hi Dan,Please also tell me if i want to create any Vlan for this activity or its simply done with policy maps, and if vlan voice or simple.Simply i have to sell /16 ips to my client with 15MB voice bandwidth so that he can use it for voice traffic.Th...
Hi Dan,Why we are not using srr bandwidth queue command on Gig port where client is connected?and where can we do routing for client as we have give 16 chunk of ips to client with 15MB bandwidth, ?routing on 7200 or 3750 ?Please explain a bit more co...
Dear Denisov,Actually 1256 is the code which generates IVR " enter called number " to calling party, and then my softsiwtch made routing decisions based on numbers which are coming in DTMF as called numbers.Softswitch only make decision based on call...
