Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I'm trying to configure pvlans over a vpc but the vpc seems to be down. I've tried searching for documentation on pvlan & vpc interoperability but couldn't find anything so far. Could anyone shed some light on this? My outputs are as below....
Hi All,I get the following error %ASA-6-106015: Deny TCP (no connection) from coa-dun-web1-front/80 to sol-dun-hobbit1/50692 flags SYN ACK on interface internal-vlan-20when I try to connect from sol-dun-hobbit1 to coa-dun-web1-front. Now, there is a...
Hi,I am trying to shape traffic on a gigabit interface (hardware is an LC single mode module) on a 6500 to 280Mbps. The interface mode shaping command lets me shape only upto 100mbps. policy-maps allow me to shape at more than 100mbps , however, whe...
HI,Is there any way to increase ASA throughput. We were conducting tests using bbcp (large file transfer program) between two solaris boxes. When these boxes were connected together (the whole network infrastructure has gig interfaces) either through...
HI Guys,How can I know why CBAC drops a packet. For example, the log I recieve for a dropped packet is .Jul 30 11:42:01: %FW-6-DROP_PKT: Dropping tcp pkt 191.147.27.13:42423 => 111.136.132.36:80(IP addresses have been changed)How can I know why this ...
Hi Joe,Did you get your sorry page to work? I noticed that the documentation athttp://www.cisco.com/en/US/products/hw/contnetw/ps789/products_configuration_example09186a0080093de8.shtmlsaid "This configuration is useful when you use only one web serv...
False alarm, I couldnt get the nailed option to work.for those intersted , I found this on cisco,http://www.cisco.com/en/US/docs/security/asa/asa70/configuration/guide/failover.htmlCheck section on Assymetric routing.However, I couldnt use this eithe...
thanks mate,that explains a workaround for the problem, however, I donot understand the solution. I cant get any documentation for the "nailed" nat option. Is there any way you could help me out here?