Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a WAN(SHDSL) link between 2 sites, serivce provider has MPLS core network. Site 1 -- Cisco 878 -------- MPLS CORE ------- SHDSL MODEM(BRIDGED) ---- Cisco ASA 5505 --- Site 2 I want to prioritize the traffic for Port TCP 3389 between sites, I h...
I have a WAN(SHDSL) link between 2 sites, serivce provider has MPLS core network.Site 1 -- Cisco 878 --- MPLS CORE --- SHDSL MODEM(BRIDGED)---- Cisco ASA 5505 --- Site 2I want to prioritize the traffic for Port TCP 3389 between sites, I have been tol...
I need to see the actual connection speed on which the link is established on cisco 857w ADSL2+ router. Can anyone help with the related commands or point me where i can find it in cisco SDM?ThanksMuhammad
When i configure one of ethernet interfaces on ASA 5510 as DHCP client it obtaines the lease from DHCP server but it does not release the lease even if i disconnect the interface from the network it stays in "RENEWING" state and show it in ASDM DHCP ...
I think we getting to the point where we started, ASA is not letting me mark the traffic, or may be i m missing something, have you experienced this kind of QoS with Cisco ASA?
Sorry about that, my objective here is to achieve end to end QoS, to get that packet to be prioritize through out the core network to the other end.LLQ is definatly not suitable for me.
Thanks everyone for the replies, As i mentioned in my initial post, i dont get the option of marking the packet (SET PRECEDENCE) when defining the class-map all i get is "match" there isnt any "set" option available to use, Site 1 router's Qos config...
Is the NAS connected to the same subnet as the windows server? what protocol VPN clients using when connecting to the windows sever? Could you post the config of your 1841?
