Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was contacted about a Unity 4.2(1) problem someone was having last week. From my initial investigation, it appears that failover is not working at all., due to the fact SQL replication is broken. The event log is logging the error "SQL Server rep...
I have the Cisco IP Communicator 7.0.5.0 and I'm running Cisco VPN 5.0.04.0300. I get dial tone and DTMF tones, but no audio on the call. No audio on either end. I've tried this from 3 different networks using VPN and it worked on 1 out of 3. Any...
I'm looking for anyone with any information on a 4E vs 5E T1. We have a location that is having a LD T1 replaced and they were told they are going from a 4E to a 5E T1/Circuit. The circuit is connected to a H.323 gateway. What changes would be mad...
Just recently I noticed that 2 out of our 32 Unity VM ports are registered in Call Manager. The status is "Unknown". I've tried resetting them in Call Manager and in Unity. I also tried deleting one and adding it back in. The ports have been fine ...
I'm trying to setup a call handler to forward to a 1-866-xxx-xxxx number. The call is not going out. I added the pattern to the Default Transfer restriction table and I tried putting it in the CS_Deafult_System_Transfer. Which restriction table sh...
That link did, but didn't help, but I did get it working!My regular account I logon to the computer with does not have Administrative rights. I did a RUN AS on IP Communicator and ran it as my administrative account and then I had audio! Closed dow...
Does the phone keep ringing when you pick the handset up? When you go to place a call, is there a delay in getting dial tone when you pick the handset up?
My problem ended up being a bad VG248. After the part was swapped out, the problem went away. I did try downgrading the firmware because there was a bug in the version I had, but that didn't fix it. It was a hardware problem.
