The following command on the router will display what signatures are loaded: show ip ips signatures. Loaded (unretired) signatures will show with a "Y" in the "Cmp" column of the command output. Additionally, the IPS Signatures GUI in Cisco Configura...
Follow these steps after choosing the Schedule tab within any report type. ----------------------------------------------------Step 1 Check the Enable Schedule check box. Step 2 Specify if you want the export format to be .csv (a file containing the ...
To copy the startup configuration file from the Flash memory SIMM to a Flash PC Card once the Flash PC Card is formatted and ready to use.Copying the Startup Configuration File to the Flash PC Card.8540CSR# copy startup-config slot0:To create a backu...
Try to reconfigure your SNMP configuration. And try. If still you are getting same problem then only solution is to upgrade it and use some other NMS tool.
This can be done by setting the Calling Party Transformation Mask to something like the Main Number on the Route Pattern(s) that are matched the outbound calls.
