Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All
I have issue with ABF for incoming traffic with label. And from my research I found this word "ABF is not supported for incoming labelled/MPLS packets." in this forum. I just want to make sure this is still not support or it work right now....
Dear All We have existing CRS1 to do the IIG (International Internet Gateway) and will replace soon. We are looking for ASR9K but my boss asking me why we need ASR9K? Why don't we choose N7K which is lower price? I know that ASR9K focus on servic...
Dear All From cisco document 6500-sup720 and 7600-rsp720 are support IPv4 unicast and MPLS—512,000 routes by default. On my network we have route more than 400K which nearly reach to the limit then I tried to change from 512K to 1007K as below.Router...
Dear All Normally when we do HSRP with vPC on N7K the device will be Active/Standby in control plane but it will be Active/Active in data plane. In this case any traffic reach to standby device it can forward traffic directly to uplink which is n...
Hi All I got the problem with L3VPN on ASR9K which has topology as below;CE1<--->PE1<---->PE2<--Gi0/0/0/0-->CE2 << I used subinterface for this link <--Gi0/0/0/1-->CE3 << I usde routed interface for ...
Hi Xander
From my understood ASR9K separate control plane and data plane. But when I look inside architecture then I have question here.
- Base on communication control plane messages (such as BFD) between LC-CPU and RSP-CPU, What's channel for thi...
Hi Xander
Someone told me try strict mode and it work for my issue. During damp time ospf neighbor will force to down and waiting for bfd.
RP/0/RSP0/CPU0:ASR-1#show ospf neighbor Mon Jul 24 23:33:54.886 UTC
* Indicates MADJ interface# Indicates Ne...
