Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have bought a PVDM4-32 Voice DSP Module for my ISR4331 and a new interface turn up: Service-Engine 0/4/0I have checked the complete ISR4000 configuration guide, but there is no guide how to setup or what to do with it.The PVDM4 guide has even le...
Hi All!I wanted to replace my ISP router in my home to a Cisco 4331 ISR with 4-Port Layer 2 Gigabit EtherSwitch Network Interface Module to improve stability and speed. Is there any trick I missed to setup this interface module? Whatever I try the in...
Hi,I have an ISP wireless router which coverage isn't enough for the whole house and I'd like to extend the wifi to reach everywhere in the house. I have some older autonomous AP that can be setup as a repeater to extend the coverage, but unfortunate...
I bought this switch to my homelab to merge gigabit and poe into 1 switch. As it was second hand, I restored the factory default, read the manual, but it doesn't work at the very begining. I'm able to make new vlans, but they aren't enabled even if I...
Hi,I practiced to use the embedded service engine on a C2911 ISR router. The router originally has 512MB memory, I borrowed a 2GB module from an another device. As the memory was needed in the original device I removed it and forgot it for a while.No...
Thank you both, I will try it next year. Unfortunately I won't be able to get a card until Christmas, so I will find other things to learn for the Christmas Holiday.Merry Xmas!
Sorry, I don't have experience in IP telephoning and the checking the forums I found out I need an T1, E1, and G.703 Multiflex Trunk Voice and WAN Interface Card, Voice Interface Cards or Channelized T1/E1 and ISDN PRI card. None of them seemed to be...
