Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What do I need to do to make video calls in Deskphone mode work? Am I missing a parameter in de jabber-config.xml?In CUPCv7 is was working fine but with the new Jabber it's not.IPPhone has Video Capabilities Enabled, Laptop has integrated camera but ...
I've got a Cius registered to the same CUCM (v7.1.5) as the CTS endpoints.When I place a call, it's audio only.Any suggestions what more is needed? Other components are CTSMAN and CTMS.Sent from Cisco Technical Support iPad App
Hi,Is it possible to visualize the current SLA in Supervisor Desktop?I'm running latest release of UCCX (8.5) with Enhanced Agents.Only way to see SLA now is with Historical Report.Thank youSent from Cisco Technical Support iPhone App
Hi,I've got 2 TelePresence rooms which keep giving MS Exchange Synch Errors in the TelePresence Room Status Overview.When I schedule the room, everything is ok (room accepts, meeting is succesfully scheduled and the MS Synch Error is gone), but after...
Hi,In the TelePresence meeting confirmation (when scheduling through email) there is a link provided which you can click to change meeting settings.This url is setup with the hostname in the URL: https://<<hostname>>/admingui/...Is there a way to cha...
Got it working and it's pretty straight forward.Can call both CTS endpoints as well as C-series and EX-series through VCS.Sent from Cisco Technical Support iPad App
That's no problem. You can even do the camera setup.What I've done earlier is install a CUCM on a small server or vmware with the correct ip address AND firmware., take a switch an you can register the cts, you can upgrade to the correct firmware and...
Take a good look a your Route Patterns and try to specify them, if there is an exact match it should ring after a single ring om the deskphone.Sent from Cisco Technical Support iPad App
Your DHCP server already had the mac addresses and the phones just kept the last one because the DHCP wasn't giving out new addresses.If you had a lease time, it probably would have as well.Sent from Cisco Technical Support iPad App
Have you tried to clear the dhcp bindings on the router?Otherwise just remove the dhcp pool and reconfigure it.Sent from Cisco Technical Support iPad App
