Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello !!I'm facing a problem using the CISCO RV220W router firmware version 1.0.3.5. At this customer we have the follow network desing : Central office -> One IP PBX -> one RV220W ->Wan link ...
Hello everybody!I am going through a network problem and I believe to be some problem related to network design.Our network is distributed in two sites, each with 2 routers interconnected by two different data link.The main link (fig.) is connected ...
Hi everybody !I have some doubts about how to do traffic shaping !We have a router Cisco 1900 series (1921), with one 4-port fast Ethernet L2 card (HWIC-4ESW), and two GigabitEthernet ports.LAN side is connected to HWIC wich is a Layer 2 interface, a...
Hello !We have been facing a problem at my company ! We have a Cisco Router 1921 with one HWIC-4ESW in trunking with a RuggedCom switch RSG2100.When I use the GigabitEthernet port to make a trunk, I create 2 sub-interfaces (one for each Vlan) and con...
Good Morning people !I own the equipment VG204 in a customer and need to know how to use the SIP protocol in this equipment ? I can't find any document on Cisco webpage explain how to use SIP protocol.Another question are : Can I use this ATA with on...
Thanks for you two !!The VoIP and CCTV traffic are very controlled, it's only a maximum of 2 simmultaneos call using G.729 codec.In this case do I need to configure LLQ ?Where do I configure the LLQ ? Police-map, class-map or interface ?thanks again
Ok Now it's working !But now other problem appear !The trunk (fast 0/0/1) with my ruggedcom network works ok, intervlan routing is working and so. So now I link other port in trunk at same interface ( fast 0/0/3 ) with another swicth from 3com. When...
