Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working to get alerting for up\down state on a metro ethernet point to point connection between our two data centers. I have configured the IP SLA Echo operation w/ track and using EEM on 9300 switch at the primary data center (DC-1) to send a...
Hello - Is there a way to be able to change\manipulate the lease time for the VPN Pool on the Cisco ASA. Also, can I just set up a dhcp scope out side of the ASA for VPN? if so, can you please provide a link or doc on how to do this? Thanks a lot,...
We just got installed a METRO LINK between our primary and secondary data center (Site-A <> Site-B) I would like to be able to route data replication between these two sites over that link, instead of going over MPLS. We run EIGRP internally and BGP...
I would like to know if there is a way to set up the default group in the Cisco Anyconnect secure Mobility Client (ssl vpn) For example: In our company we have more than one ssl vpn group that are available to remote users (based on their job roles,...
I am in the process of configuring RADIUS authentication on our network devices. But I also use SolarWinds network configuration manager to manage\back up the device configurations. I would like to use Radius for when someone needs to access the net...
Ok, is it possible for you to provide a sample config or a link where I can find that? I have research for a bit, but I haven't had any luck. Could the EEM check for down state and continue to alert via email until state changes to up? Thanks again,...
Thanks for the replies. I will be testing both solutions, but I think our mgmt would like to have SW to use the local account. Thanks again. marramix01
Thanks a lot for the feedback, it clears a lot of things when it comes to making a decision. Yes I saw that 5672 comes with two more 40Gig interfaces than the 6001 witch is it a plus. Thanks again, marramix01
Inside 10.250.11.10,11, 45<----asa----> outside 167.165.10.1 <-Internet> 155.16.35.1 outiside <-vpn device?> ---10.250.11.0 I am not familiar with their set up, but the only thing I was informed was that 10.250.11 might be used on their end internal...
