etxnreg
Level 1
Level 1
Member since ‎08-08-2003
‎06-20-2021

User Statistics

  • 42 Posts
  • 0 Solutions
  • 11 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
First Discussion
40 Discussion Posts
5 Discussion Posts
30 Discussion Posts
20 Discussion Posts
10 Discussion Posts
1 Reply
10 Replies
5 Replies

User Activity

Hi,Trying to setup rip over a l2tp tunnel (ipsec).In the other end I have a windows machine that using the rip listener.Can't get it work.Should it work?Have any some one any ideas how I should do the config?//Niklas
Hi,Have an issue that I can't fin the reason for.We have 10 spa942 phones.Some time the phones sending a bye message directly after you have answer the call.It happens approx 5 of 100 incoming calls.Has someone any clue why?Could it be any parameters...
HiHave following issueInstead of displaying the user's calling ID, the group number shall be displayed instead.Our sip proxy is fixing this.When I had done that, the problems started.The spa942 will not longer response on the 200 OK.Thats means that ...
Hi,Have a question:Have a numbers SPA942 with a group number and a DID number.If I want to make a call transfer between two phones, I must dial the full number to the C-user. reason is that  the A-part comes from the PSTN gateway.Is it possible to co...
Hi,What command should I use to see how much outgoing traffic is in different queues, when using mls qos?interface GigabitEthernet3/1 no ip address wrr-queue bandwidth percent 18 80 2 wrr-queue cos-map 3 1 1 wrr-queue cos-map 3 2 6 7 mls qos trust...
Community Statistics
Member Since ‎08-08-2003 12:08 AM
Date Last Visited ‎06-20-2021 11:53 AM
Posts 42
Helpful Votes Given To