Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I upgraded my MC03A to 4.2.10 but now,When I try to create a conference I dont see any services other than message in the prefix box saying: "No services are configured in the mcu"I returned back to 2.2.75 and start upgrade to 3.2.138->3.2.224->...4...
I have this scenario,I want translate or forward an internal extension number to an international numberSo when any extension dials that four digit number like ?2525?, callmanager translates that numberTo 0114512312312? ,Should I use translation pat...
i don't know, but it seems i made a stupid mistake somewhere in my config.i have this router that works fine when it's connected to my callmanagerand when i disconnect network for srst test , it goes to fallback and everything works fine but if i cal...
i have a remote site(SRST)2821 connected to my main callmanager , i can call all the extensions internally without any problem, but when i transfred an incomming call from from my pri gateways to any of the remote extensions, they can't here anything...
i have 2 routers 1-Cisco 1700 with ip address 10.0.0.10/16 connected to 2nd routher Cisco 2851 (10.0.0.9/16)on the other port of 2851 i have another netwotk 10.1.101.0/24 and on the other port of 1700 i have 172.22.22.0/30i used eigrp 100 on both of ...
i have the exact same issue, and i did what you mentioned,first , when i downgrade to 3.5.24and i try to reset factory default ,(press 'a' and prese '2')i get the message says nothing changed.i tried all versions an in 2.2.75 i was able to do reset f...
