Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The ios command media flow-around seems to be missing in my command set event though the release notes says it should be there. Any one konw whet version it is in. I am onisco IOS Software, 3800 Software (C3845-IPVOICEK9-M), Version 12.4(15)T9, RELEA...
A switch with one voice vlan and a mixed set of users such as IPT users connected to a IPT cluster and call center users connected to a call center cluster. Having an issue trying to deliver opt 150 to them uniquely. dhcp does not seem to have a mac ...
When using B-ACD with IP Communicator phones the auto logout feature puts the agent in a not ready state. This works fine but I cannot see how to make them ready again.Any help would be appreciated
With CVP 4.0 I am wanting to use B-ACD as the fallback queuing on the edge router. The supported router is IOS 12.4(6)XT which uses SRST in fallback mode and hence no queueing. Anyone used B-ACD on IOS 12.4(6)XT?
that is good to know. This is what I found See this excerpt taken from the link below:Restrictions •The HLog soft key is available only on display phones. It is not available on Cisco Unified IP Phones 7902, 7905, and 7912; Cisco IP Communicator; a...
ThanksI do not think it applies to B-ACD as per the description in the manualLogin-Provides personal identification number (PIN) access to restricted phone features.
