Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When trying to upgrade Cisco ISE, I must first complete the checks beforehand to do so.The only error I get in this regard is with one specific node:Running the command mentioned on the CLI of this node to see further details just gives me the below ...
Hi all,
I am building a basic eBGP lab to test out the concept of making 2 non-directly connected neighbours BGP peers.
The network the BGP routers will be going 'across' is an OSPF network.
The lab is below along with relevant configuration:
...
Hello everyone,
Topology
I have built the below lab in my spare time and very briefly here is an explanation:
The main routing is done via OSPF apart from 2 BGP Routers circled in Blue on the outer sides.
The OSPF routing works absolutely fine and I...
As far as I can make out, the firmware is quite simply the software it runs, pretty much like any device nowadays. However I cant put my finger on what exactly the purpose of the Config File is.
Is anyone able to help me clarify this concept?
I know when you want to reset the password for the Call Manager 'Administrator' account, we can do so by accessing the CLI and using the following command:
utils reset_application_ui_administrator_password
However, as per my understanding, this is ...
Hi Jon,
Thanks for pointing that out, not sure how I missed that. I changed the neighbor to 10.0.0.5 instead.
As requested, the Routing Tables of R4 and R5 are below:
R4
Gateway of last resort is not set
10.0.0.0/8 is variably subnetted, 2 subne...
Hi Pigallo,
To answer your questions:
Yes I did. I advertised that entire subnet (on both Routers) within the entire OSPF processYes I did. I figured out that the problem was me setting the multihop to 2 instead of 5 as I should have
Hope that helps....
Great, thank you.
Seeing as this is the case, when a phone boots up and receives Option 150 from the DHCP Server, it has the addresses of the Call Manager (TFTP Server).
Does it now pull the Config File? What about the Firmware?
My understanding is t...
