Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community, I have a pair of WLC 9800 in HA mode. The management interface labelled SP on the standby WLC is down, lights out even though it is configured the same as the SP port on the primary (different IP). Is this normal behaviour?
Hi all, I have a Cisco 2960 switch running IOS 15.2(7) E7. I configured NAT overload.Straight forward config:interface Vlan150description INSIDE-LANip address 10.150.0.254 255.255.255.0ip nat inside!interface Vlan192description OUTSIDE-LANip address ...
Hi, I have a lab DNAC version 2.2.1.0. When I go to the software update page, it only offers version 2.3.5.3 and according to CCO, this is not a valid upgrade as there should be an intermediate step - version 2.2.3.6. I was thinking of taking a backu...
Hi guys,Please see the attached diagram,I need to set up two factor authentication for users that Anyconnect into our ASA. The management would like to use Azure MFA. Is this doc a good guide? https://download.microsoft.com/download/4/5/7/4579C1CF-35...
Hi guys,Please see the attached diagram. This is the network setup of one of our customers. All sites use Cisco ASA firewalls. They have an existing VPN to site A with multiple subnets & variable subnet masks. I've only shown a small number of subnet...
So I really need a small lab device with these features:- Small switch 8 or 12 ports (to remove the fan noise)- Gig Ethernet ports- PoE- dot1x- NAT- IOS 15My little 2960 does all of the above except NAT.
Yep, it accepts the commands and also performs NAT when the traffic is sourced from the switch's own interface:Here is a NAT debug:SW1#ping 8.8.8.8 source 10.150.0.254Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is...
