Using CUCM ver 10.5.2.13900-12
phone using SCCP41.9-4-2SR1-1S firmware
Phone will not show calls in the directory screen. Other 7941 phones are working with the same firmware load. Replacement phone installed same symptoms.
I have 10 elevators that use an analog dialing device with no handsets. After a call is placed there is no way to hang the device up. After the call is terminated the speaker will start sending out the "reciever off hook" tone for up to 3 minutes be...
The scheduled video presentations will play fine. But if I try the On demand or Videos to playback I get a message at the bottom of the player that says "you are not authorized to access this VOD file Content Manager 10.x.x.x " Any ideas on what i...
Looking for some help with this issueCisco 7940 will turn on and display configuring IP, Configuring CM list, then goes to "Compression Type Error". Debug report 0x810D, 0x0, 0x12300800 This code repeats itself on the report each time the Compres...
Deleted the ITL file and reset phone. Checked DN in call manager and it does have the check on log missed calls. Factory reset on phone as well. Still no calls are showing as missed, received or placed.
If you have auto assign extension enabled when you add a new phone to the system you may also look to see if the directory number range pool is full. From menu Call Routing>Directory Number Then remove numbers as needed.
