Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,we are running a cisco 4503 with bootflash:cat4000-i5s-mz.122-20.EW4.bin IOS on that, we are informed to upgrade the IOS on that. However, no info on which IOS has to be deployed on that. Hence, can some one please suggest the latest and up...
Team, Need a help / Suggestion on the VRF to route the multicast traffic between the vlansThe problem is something like this [ Refer Diagram below ]We have a source residing on the Vlan X on the Catalyst 4503 and the clients will be on the Vlan Y on ...
Team, Need a help / Suggestion on the VRF to route the multicast traffic between the vlansThe problem is something like this [ REFER ATTACHED DIAGRAM ]We have a source residing on the Vlan X on the Catalyst 4503 and the clients will be on the Vlan Y...
Hi There - I have got a new 48port Cisco catalyst 4948 switch, which I configured as a VTP client and connected to Cisco 3750 which is a VTP Server (this switch is on production network). I connected port g1/0/48 from 3750 to port g1/48 on 4948 throu...
We have Cisco wifi setup at our office. Till now we had cisco Aironet access point -1000 series and the cisco Express- 500 series of switches. These switches inturn connects to wifi controller ( 4400 Series) we do have wifi control system centrally ...
Hi Surendra - Good day !I have executed the command you mentioned from AP's console. But, it didn't gave any result / it didn't reboot even after 20 min .. ThanksPeter
Hi Surendra & Fede Thanks for your responseI have configured a static IP on the AP from the same range of controller (Since our controller is on LWAPP Transport mode – Layer 2) I could able to ping Controller and from controller I could able to ping ...
Hi, Thanks for your reply. You can see above that I have copied the interface status and where in both status doesn't seems to be on err-disable. As I mentioned 3750 is already on the production network with many trunks connected to cisco 2960 and ot...
Hi SurendraThanks for your reply.Your suggestion is never rejected rather got little delay for replying (I apologies!). Pls see the result of show ip int brief below. I also noticed that on the switches all ports are configured as SMARTPORT. APc84c.7...
