Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
CER 8.6
Is there any way to clear the ERL assigned to a switch port? (under ERL Membership -> Switch Ports)
When selecting "Edit View", there is a little warning that states: "ERL Name cannot be removed from the table view"
So...is there another pla...
Having an issue with Call Forward All (CFA) CSS when using the Line/Device CSS approach.When I configure a CSS for CFwdAll (using a LINE CSS), I can't CFwdAll to any internal DN's (call cannot be completed). If I use a Device CSS for CFwdAll, then th...
Have CUCM 7.1(3), configured to sync with Microsoft AD (2003)When we first configued the LDAP sync, CUCM was able to pull in all the existing users in our OU's.We recently added a new OU with a couple of users, gave the LDAP user "read-only" rights ...
Having an issue with Cisco Unity Express. Have one user that is unable to listen to messages via TUI. When the user receives a VM, the MWI light goes on as it should and they get the message via email, but when they call into CUE, it says "No New M...
Trying to upgrade an AIP-SSM-20.We have 2 ASA's in a failover configuration, the upgrade on the secondary AIP-SSM-20 was successful.On the primary AIP-SSM-20 we are getting the following error when trying to upgrade via FTP from the same server that ...
I had this same issue. What I found was that it was an issue on the client with the AnyConnect profile file. After upgrading the client, AnyConnect would come up with the connection as something like "MARS-5506X (Ipsec) IPV4" (at which time it did n...
You can set the timezone for FMC users under User Preferences - Time Zone Preferences.When logged into FMC, go to to the username in the upper right hand corner select <username> User Preferneces This should display all time entries in the timezone ...
Thanks Brandon, that does help.One additional question, How would you configure CSS's in the case where you want to limit the CFwdAll to a "lesser" COS (Line can call LD, but only want to allow CFwdAll to Local or Internal numbers)?Thanks again.
I think we have resolved this.It turns out the AD admin didn't configure Last Names for the newly added users. Once we configured Last Names in AD, the users sync'd....so Last Names are required.Thanks for all suggestions.
