Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, there,I am working on a NAC Guest project where I need to do web-auth for wired-guest users.I read through the doc "IBNS: Cisco Integrated Local Web Authentication Deployment and Configuration Guide" and able to get NGS working with ACS via inte...
Hello, All,I am trying to find out the Cisco recommended UCS BIOS setting for UC on UCS deployment. Should I turn on Hyper-threading for ESXi if the CPU supports it?Is there a document just to talk about any BIOS/setup recommendation setting specific...
Hello,I am working on a project where I need to deploy CUMA 7.1.3 and integrate that with Blackberry devices. According to Release Note of Blackberry Client 3.1.12, Blackberry Bold 9000 is a supported model. However, I am not able to select that from...
Hi all,I have a router-on-a-stick scenario where I have 7-8 subnets configured as sub-interface on a gigabit interface on a Cisco 3825 router. Only 3 VLANs are active now.Say vlan 10=pc data, vlan11=voice, vlan1=apple MAC server.When an apple PC/lapt...
Hi,there,I can't seem to find a Cisco doc saying W2K8 AD is supported with EXCH2K7. I realized there is a MWI bug related to W2K7 EXCH with W2K8 server.Is W2K8 AD with W2K7 EXCH supported by Unity 5?Thanks,
Hi, Tiago,I read through the doc you mentioned above and able to get NGS working with ACS via internal database or AD for wired web-auth. Which means, when I plugged a guest PC onto the network, open a broswer, enter either a ACS internal user ID or ...
I have the exact same issue. I saw the vpn client showed that it was uploading (counter increased). but the progress bar stops. Is there any solution for this or am I just not patience enough??Thanks,
Hi, there,I will need to make a cable for 3.5mm to RJ45 which will connect to E&M port. But I am having hard time to resource such special cable. Do you know where I can find these type of cable?Thanks,
I uploaded the client 3.1.12 to BES(4.1.6) and the BES said (under the Software deployment policy) the device is not supported. And I don't have the client icon on the phone.I will wait for another couple hours to see if the BES pushes the client.
Jeff,I had a similar issue with Bulk edit for MWI in Unity 5.0. First of all, if I add subscriber using template that has MWI enable and then disable them in Bulk edit, the SA page won't refresh the setting untill I do a search of subscriber again(me...
