I have a 4507 with Netflow. Am I correct in understanding that I can only see the flow of one interface? I want to try netflow but am moving cautiously and know there is a lot of traffic on this switch as it has 75+ servers connected.
I want to see device 10.9.1.1. It is a 4507. I set it as the seed. I search 10.9.1.*. It's SNMP RO string matches on the config and snmp settings screen.I get a report that indicates unreachable. I can ping the 4507 from ciscoworks. What should...
I have 2 4400 controllers. Each is located at a different site and the access points at each site will have a primary and secondary controller. Each site is on a different subnet. When the link between the sites fails then each site works fine as a...
I had planned on putting: clock source line independent on each controller but "independent" isn't recognized. I am planning on using multilink with 6 T1s between two identical 2811 with one side as internal and the other as line. I understand that...
I am having trouble connecting an "el cheapo" switch to a 2948G. I have set up a training room and needed a high density of PCs so I plugged a switch into a 2948G port. There is a button for up-link abd I get a link light and the 2948G indicates it...
I put that command at the top level; that is not as part of an interface and I have seen lots of flows when I do a sho ip cache flow. My guess is that I am looking at all interfaces and if I wanted to troubleshoot one interface then I would apply th...
Sorry about that. 2008/02/07 16:39:18 main MESSAGE DiscoveryMain: Properties will be read from C:\PROGRA~1\CSCOpx\campus\etc\cwsi\DiscoveryStatus.properties2008/02/07 16:39:19 main MESSAGE DBConnection: Created new Database connection [hashCode = 62...
000642: Feb 7 13:12:53.894: SNMP: Packet received via UDP from 10.9.3.116 on Vlan9000643: Feb 7 13:12:53.894: SNMP: Report, reqid 1, errstat 0, erridx 0 internet.6.3.15.1.1.4.0 = 21000644: Feb 7 13:12:53.894: SNMP: Packet sent via UDP to 10.9.3.11...
