Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I want to register ATA-191 with CME (2911) version 10.0. Please refer my configration as below:ip dhcp pool testnetwork 192.168.31.0 255.255.255.0option 150 ip 192.168.31.2default-router 192.168.31.1!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!voice r...
I have two CME - 2911 which version 10.0 and version 12.0. I try to SIP trunk between two CME each other but I encountered some problems as follows:- I can call from SCCP phone (registered CME-1 version 10.0) to SCCP phone (registered CME-2 version 1...
Dear Sir,
I have CUCM and cisco mediasense server 11.x. I am using a lot of Cisco 7940 IP phones in our network and try to record the cisco IP phone 7940 phone calls. But I am not able to record the 7940 ip phone in mediasense server because C7940 d...
Hi Experts,
I am using PI 2.2 to monitor the cisco switches in my network.
And recently my customer want to monitor two dell Edge server from PI. Therefore,
I configured the SNMP on Dell servers and I discovered from PI.
PI is showing those Dell se...
Hi ,
I installed Cisco attendant console standard 10.6 on window 7 ( 64-bit ) and successfully registered with CUCM 10.5.x.
After that , login to Cisco attendant console and try to call to other IP phones. I can make the call and other IP phones is r...
hi, Thanks for your support.I have already tried your below configuration. But, ATA-191 has not found ATA configration file (Config.xml). Please help me!!!
hi,Yes, correct. All telephones will be unregistered when the call are working between HST and TLJOC and request timed out when ping to IP address of PABX-HST.
hi,Thank for your support.After I revised my configuration follow your advise. I have a new problem:- when I call from SCCP phone (registered HST) to SIP phone (reigistered TLJOC) or I call from SIP phone (registered TLJOC) to SCCP phone (registered ...
Hi, I already applied the command "Session Protocol Sipv2" on dial-peer from HST to TLJOC and from TLJOC to HST.- After that I can't call from SIP phone (registered TLJOC) to SCCP phone (registered HST).- when I call from SCCP phone (registered HST) ...
