Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I was supprized that PGW 2200 is part of HCS suite while there is a EoS/EoS announcement for PGWhttp://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/vcallcon/ps8362/product_data_sheet0900aecd80670040_ps556_Products_Data_Sheet.htmlhttp://w...
Calalyst 3650 (IOS 12.2(25)SEE2) as a L2 switch.I want to block all L2 traffic between two MAC addresses.One MAC is a IP-Phone and the other MAC is the local Voice Gateway. IP-Phone and Voice-Gateway are both in VLAN 10. Both MACs are attached via VL...
How do I switch a ATA186 to SRST mode without disturbing other network services and devices?I have to check SRST functionality (switchover & fallback) and I only have access to Callmanager 4.2.3, the Voice Gateway (H.323) and the ATA186 itself. The v...
Hello,I use freeRADIUS to authenticate WLAN Clients. Traffic is encrypted with WPA and clients are authenticated with LEAP or PEAP.The AP 1220 with IOS 12.3(8)JA2 works well and the configuration is the same for PEAP and LEAP.The value "Session-Timeo...
HelloSUP720 is delivered with 64MB onboard flash. Newer images require more memory. Do you have an idea howto upgrade the onboard flash? Or do we have to order a CF-Card?Peter
I am just troubleshooting the same issue:Dialing Outlook contacts or using Cycos Cyphone seems to stuck: Associated phone goes off-hook but it takes 15 seconds until phone is dialing. Both applications use Cisco TSP and I have opened the second case ...
CCM 4.x accept static routes but CUCM 5.x and 6.x do not (see SR CSCse56091)So you have to configure the device with a wrong default gatewa address. But be aware, you might rech the device never again A better solution is to setup a VLAN Filter on a...
It works!You only have to ad a second entry in the ACL and pay a little patience.I have modified the ACL for matching both directions:!mac access-list extended srst permit host 0090.0b08.0507 host 001a.2f80.33cd permit host 001a.2f80.33cd host 0090.0...
That problem is well-known and caused by Web Browsers language settings!Workaround: Set Browser to en-USSee CSCsl34597 or CSCsi48388 for more details.Kind regardsPeter
This is a drawback of CCM 6.x and earlier!CCM supports "Invite with SDP" (=SIP Early Offer) only when an MTP is asociated to the SIP trunk.See SRND (Based on CUCM 6.x) page 5-17But don't think that this is the solution: All MTPs (SW/HW-based) are lim...
