Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have four SVIs in the same HSRP group. I need to increase the size of the subnet by changing from /22 to /21. the SVI IP and gateway wont change, just the mask. Is it safe to do this in production hours or can it cause issues?
Im moving a HA pair 9800-40 WLC from location to another. Is it possible to just change the management IP addressing and the failover IPs via cli. I can find plenty documentation on configuring out of the box but nothing on how to move them.I didnt w...
Hi. Is it possible to use FQDN in a manual nat rule.The aim is to permit inside IPs to an outside cloud domain and nat to a specific public IP.The acl works with a FQDN object containing a URL. The URL is resolved in DNS and traffic flow allowed.The ...
how do you see output on a Firepower cli that is manged by FMC. Im trying to run debug crypto ikev2 protocol and platform. I dont see any messages in the FMC syslog
Im building two Dot1x policies in ISE. One wired, the other wireless. As the end devices are the same and can connect either wired or wireless, the only difference in the policy is the wired or wireless dot1x condition selected from Condition Studio....
I came across this post while investigating a similar issue. I found the solution to this via TAC. I thought i'd chare in case anyone else has this problem.Wireless > 802.11a > RRM > DCA, just check "Avoid check for non-DFS channel" and then remove t...
Im replacing some 5520s with these 9800s so an interim measure will be to move all APs to the 5520s while I move the 9800s into place. 5520 software and older APs have been upgraded during this upgrade process.I did consider creating a second SVI fir...
In the video hes using a host object in the original destination. As my original destination is a cloud based IP it needs to be a FQDN in order to look up the destination IP. The FMC will not even show a fqdn object to select in the original destinat...
the logging level was set to errors. ive updated this to debugging but still dont see anything in FMC syslogs.how do I enable monitor logging so i can see debug on local CLIThanks
