Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we had several speaker track 60 array build into conferencing rooms. However we moved and in the new building they have been replaced by room kits or room systems.We have a large room where we need several cameras so i thought we rip those ST60 a...
Hi, we have recently bought 2 3241 ISDN Gateways. The initial configuration was easy and calls are running in and out. Unfortunately the Gateway doesn't send the calling party number in the correct way to the isdn switch. For example: A DX80 registe...
This is just a business decision. You can open a feature request at Cisco TAC and forward this to your account team. Maybe something changes when there are enough people asking for it.
Hi,unfortunately WebRTC is disabled or at least access to the webcam and microphone is disabled when the device is registered on premise only. You can create an Webbrowser button and connect to the meeting but therefore have no audio and video. I ga...
Hi, the switch is soldered to the back side of the camera. It is a small silver part. I've removed it and soldered a bare wire between the two former switch connection points.
8000 phones means that there is probably more than a CUCM. CUPS, a switchboard, shared lines, Lync or Jabber,... all subscribe to the status. A short network outage or a failover of many phones can cause problems. We observed this many times in the p...
You can configure MOH on the device pool, device and line level. When you login with different profiles, device pool and device stays the same. So there must be a difference in the line configuration.Here you can find some other hints:http://rsccievo...
