We can not get an outbound fax to complete from cisco ATA 192 but there is no issue with incoming fax. And, also tried to connect with the phone so we can communicate both ways inside and outside calls which is perfectly working fine.Any suggestion w...
Dear All,We have an issue with the one C9300-48P switches with two switches on the stack and both versions are 16.12.8. The issue is I cannot ping from any computers and when I connect to the switch it is all interface is active but uplink is not sho...
We are receiving notification on DNA that one of our switches utilizes high memory. Anyone can suggest to me what could be the reason. Watch Model: 9300-48 with stack and only 832 only free please see the screenshot. Thanks
I have downloaded latest firmware for cisco switch 9300 48 ports 17.3.5 but after successfully downloaded, it is showing unable to verify instead of verified.Please if you have any suggestion and I've attached screenshot for your reference verified m...
I have a Wireless controller with HA mode and I tried to switch over it is working in both modes primary and secondary, but DNA says the WLC controller is not reachable.I can ping to DNA from Wireless controller to DNA and DNA to Wireless controller ...
I checked all interfaces with CDP neighbors are showing correctly and also memory utilization is normal and the speed of the interface is also matched.I checked when the switch was hanged so I connect with the console and only the uplink which is con...
Thank you for all your reply. We have got again hang our switch. There are two switches 9300-48-P and both are running IOS 16.12.8 and on the stack. After reboot, it was working fine but again after my first post. Thanks
Sure, Here is the screenshot and version information. Processor Pool Total: 1452962416 Used: 385414712 Free: 1067547704 lsmpi_io Pool Total: 6295128 Used: 6294296 Free: 832 PID TTY Allocated Freed Holding Getbufs Retbufs...
