Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Switch Stack that is mixed with Cisco 2960S and 2960X switches. How can I upgrade the IOS of the switches in the stack without unstacking it.?
I have a Cisco switch (WS-C2960X-48LPS-L) that powers up then all the 48 ports are not working, the remaining SFP ports are working normally without any errors. Please find the below log and help me to resolve it. POST: Inline Power Controller Tests...
Dears, I have Cisco AIR-CAP2702i-E-K9 access point and it was perfectly working till yesterday through PoE without any issues. suddenly it's stopped and when I checked with console cable there is no response from AP and the LED is Off.Just now I have...
Hi all, I'm trying to install IPsec site to site VPN by using GNS3. the whole scenario is working fine ( OSPF & LAN networks are reachable ) but unfortunately the IPsec Tunnel between HQ & RS1 is not working.hereby please find the below configuration...
Hi RJI, Thanks for your support. now it's working. RS1-RTR#conf tEnter configuration commands, one per line. End with CNTL/Z.RS1-RTR(config)#no ip nat source list NAT interface FastEthernet0/0 overloadRS1-RTR(config)#do wrBuilding configuration...[OK...
Hi Mostafa, Please give some more information about the connectivities between the VSS and two ASA (port numbers). and post the port-channel configuration of VSS & two ASA.BR,KR
Hi Mark,Currently, I have VSL configured in Te1/0/5-6 (Po1) in VSS switch 1 and Te2/0/5-6 (Po2) in VSS switch 2 with the dual active configuration in port number 1/0/10 in both switches.
