Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Reference to the link in the url below:-http://www.cisco.com/en/US/tech/tk389/tk621/technologies_tech_note09186a00801d11a0.shtmlCan you describe what is the meaning of the statement below:-If the BPDU of the root in VLAN 1 is better than the BPDU of ...
Why I cannot configure the codec g729a & g729ab at dial-peer voice or voice codec class in AS5350XM. I noticed in the datasheet in this link for IP-IP GW,http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/gatecont/ps5640/product_data_sheet0918...
'm trying to enable T.38 Fax in my network environment using UC520. The setting is something like this:Fax 1 -- UC520 -- CCM -- VOIP -- PSTN -- Fax 2Cisco UC520 (using CME) is the originating gateway for fax 1 to send T.38 fax. It is going to the Cis...
I have implemented VOIP and CUCM for enterprise solution.My setup is like this:-Fax1>>CCM5.0>>IPIPGW(transcoder)>>SSW>>Gateway>>PSTN>>Fax2What is the possibility of FAX T38 not going through even the call signaling & setup have been established and f...
I have implemented the IP Phone on CUCM 5.0. When I call any call centre that implement auto-attendant/IVR/operator that instruct me to choose menue.gFor english , press 1For french, press 2When I choose 1 or 2 or else on the keypad, why the option i...
Thank you very much for the explanation.. really helpful even i'm not fully understand the theory.btw, what is the best setup to replace the built scenario?
