Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi;We have a CM5.0 and and alcatel switchboard. Alcatel is connected to ip network with E1 PRI at an 3845 router. When i call someone who uses alcatel, they cannot see my caller id. I couldn't fix this issue. The command debug isdn q931 doesn't show ...
Hi,We have a PRI on our gateway and CM5.0 system. When we call outside from our pri ports, only the pilot number is shown at the other side. But we want everyone's DID to be seen, when they call outside. How to achieve this goal?
Hi,We have CCM 5.0,2811 voice gateway,1 4FXO and 1 g.shdsl card on it. 4 Telco lines are on 4FXO card.CCM is at the other side of g.shdsl line.Topology like that,2811 ---------------- CCM4fxo g.shdslWhen a call receives from FXO port, system is w...
Hi;If i put an GLC-T (1000BASE-T SFP) on 6500 chassis, does it works with my 10/100 DSL modem. So; can GLC-T module set its speed to 100Mbps automatically?Sorry for this amateur question?
Hi;I have 11 1242AG access points. I have two ssids on them. One is for guests. The other one is for corporate use. I used microsoft ias for active directory authentication. It works well but sometimes users fall to "limited connectivity" situation(w...
You should set a phone button template for 7914. Under device>device setting>phone button template, find 7914 or form it yourself and select the bottons and their features(there should be a button template named 1-7914 7960). Then, select this phone ...
