Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a 2811 router that was recently uploaded with a new IOS. The router was however unable to load the new IOS as well as the previous one.All efforts to lead try and load from the flash has failed. Router just keeps giving "cannot load flash" ...
Hi,I have a client that has CME 4 installed on a router and they use 7921 I phones. There are 4 PSTN lines connected to the router allowing users to make external calls. The configuration is such that 2 of these lines ring out at specific users exten...
Hi,I have a client that has CME 4 installed on a router and they use 7921 I phones. There are 4 PSTN lines connected to the router allowing users to make external calls. The configuration is such that 2 of these lines ring out at specific users exten...
Hi,I have a site-to-site setup between a HQ and 2 branches. I however want to configure remote access to the HQ for offsite users who wan to connect from the internet into the LAN. The site-to-site vpn was achieved using Crypto Map policies to the in...
Hi,I have a direct link through fibre to a regulator's office from my HQ. We connect to this regulator's local secured network via a VPN tunnel. I also have 3 desktops that have access to this network all through a dedicated switch. One of the units ...
Hello Satish,Thanks a lot for your post. It was quite helpful. I have been able to resolve the issue by simply booting the router from the good IOS from the rommon> mode with the following command just as you stated above...rommon 2> boot flash:****A...
Hi Leo,Here is the output of the dir of the flash:rommon 16 > dir flash:program load complete, entry point: 0x8000f000, size: 0xcb80Directory of flash:2 22337524 -rw- c2800nm-spservicesk9-mz.123-8.T10.bin3642 1823 -rw- sdmconfig...
Hi Leo,Below is the console output:rommon 2 > resetc2811 platform with 262144 Kbytes of main memoryMain memory is configured to 64 bit mode with ECC enabledUpgrade ROMMON initializedprogram load complete, entry point: 0x8000f000, size: 0xcb80program ...
Hi Allan/PB,Thank you both for your immense contributions. After taking time out to study both solutions offered, I was more at home with that which Allan put forward using COR list. Though i believe using PB's idea would make the whole config a lot ...
Hi PB,I honestly am looking for the easier and faster way out.Using 'trunk XX' under ephone - how do u go about that? Is it any different from my present config?Kindly take a minute to look at what I have in my attached router config."Then put 0/0/2 ...
